How do I set up the mapper so I don't get the spider webbing affect when two points come together? What I would like is whenever I cross another already mapped area or run parallel to another line that I don't get auto connecting lines. I assume it has to do with the mapper options under the config tab but whatever combination I try I cannot seem to get to work for me.
Thanks!
Mapper Question
Re: Mapper Question
They're not really points, they're actually squares, and the centre of the square is what you see as a point.
It does the connections based on the proximity of teh centre of the squares. If it is within a specific range of another point, then it will create a connection. That range depends on whether you run the mapper in Tight mode or not. When Tight, it is a distance of 7, when not distance 20.
There's currently no way to prevent it from joining multiple points if they fall within range.
I guess it could be an option to only join to the previous node. Feature to be added.
It does the connections based on the proximity of teh centre of the squares. If it is within a specific range of another point, then it will create a connection. That range depends on whether you run the mapper in Tight mode or not. When Tight, it is a distance of 7, when not distance 20.
There's currently no way to prevent it from joining multiple points if they fall within range.
I guess it could be an option to only join to the previous node. Feature to be added.
Re: Mapper Question
Awesome. Thanks for the insightful reply Bob I appreciate the information. 