syphi.net

What am I doing wrong here I make a patrol point however when I loop it the bot just stands there and I keep getting this error.

This may happen, if your waypoints are wrong. I for example get this massage when my toon isnt near enough at my waypoints, or if my waypoints dont look like a circle.
Remember: Use the Nav Mapper under the Registercard "Debug" to find your current waypoints ( only start the bot if your are standing next to them ) and use it to make a nice Circle in your Waypoints as well.

Excuse my english


Regards

As the previous poster said, you need to be within range of you nav mesh (map) in order for it to move to it.

The range is determined by a few variables, but mainly the Insufficient Path Range, Stay On Path Range and the Stay On Path flag. If you have a read of the tool tips for these settings you should be able to figure it out.

The easiest way is to display the nav mesh, by hitting the NavMapper button on the Debug page, and then making sure you are standing on the map path before hitting Start.

Yeah I finally figured it out...the bot is not mapping correctly there are gaps in the mesh and its not linking.....was doing it again today now I can't log into the bot at all says something about a timeout