No locations sets matched our range level

This is a good place to ask general question about our products.
Post Reply
slickkilla
Posts: 1
Joined: Thu Dec 20, 2012 7:32 pm

No locations sets matched our range level

Post by slickkilla » Thu Dec 20, 2012 7:38 pm

I put my level range to be 1-30. I just basically want to do my deed killing barrow-spider. Once I want to start the bot, the error msg shows up. How do I fix this? Thanks

fighterlastme
Posts: 15
Joined: Wed Apr 18, 2012 9:09 am

Re: No locations sets matched our range level

Post by fighterlastme » Fri Dec 21, 2012 12:34 am

i think the level range should be Your Level-max level you can get in that zone.

rhui
Tester
Posts: 993
Joined: Tue Mar 09, 2010 7:10 am
Supporter: 9999

Re: No locations sets matched our range level

Post by rhui » Fri Dec 21, 2012 12:37 am

Thx max level is used, to switch location sets when you outlevel them...

For example:

LocSet 1: level 28-29
LocSet 2: level 30-32

enable both loc sets!

when your level changed from 29 to 30 you will see the bot will auto move to the new LocSet2!

bob
Tester
Posts: 482
Joined: Thu Aug 18, 2011 9:23 am
Supporter: 9999

Re: No locations sets matched our range level

Post by bob » Mon Dec 24, 2012 1:39 am

locations sets will not be selected if your toon is not within the range specified for the location set.

So if your setting the location to be 1-30, then you toon needs to be from level 1 to 30. If you are 31, then the location set will not be used for the toon.

For deeds, which you tend to go back to, I normally set 1-85 for the level, and only select the location set when I want to run it for the toon.

Post Reply